and I added the value behind hwmon1 (in italics) myself because there was nothing there before. I started with an autogen config, but when I couldn't start fancontrol did a few things - removed all references to pwm2 because all I have is a single cpu fan I'm trying to control. # Configuration file generated by pwmconfig, changes will be lostĭEVPATH=hwmon0=devices/platform/coretemp.0 hwmon1=*devices/virtual* The fancontrol script can automatically respond to temperature changesĭo you want to set up its configuration file now (y)? n Please verify that all fans have returned to their normal speed. The pwm outputs connected to the fan connectors,ĭid you see/hear a fan stopping during the above test (n)? n Or the connected fan has no rpm-signal connected to one of There is either no fan connected to the output of hwmon1/pwm2, Would you like to generate a detailed correlation (y)? n If you do not want to do this hit control-C now!!! This may cause your processor temperature to rise!!! Warning!!! This program will stop your fans, one at a time, Hwmon1/fan1_input current speed: 3191 RPM Giving the fans some time to reach full speed. Physically verify that the fans have been to full speed However, it is ** very important ** that you The program will attempt to restore each fan to full speedĪfter testing. We will attempt to briefly stop each fan using the pwm controls. Note that many motherboards do not have pwmĬircuitry installed, even if your sensor chip supports pwm.

This program will search your sensors for pulse width modulation (pwm)Ĭontrols, and test each one to see if it controls a fan on This is a an old Dell PC (i5-2320) that I put Ubuntu 16.04 on. I've got fancontrol installed, and immediately after running pwmconfig, I get a Configuration appears to be outdated, please run pwmconfig again message.

Instal the new FanControl v160